5.3 Caution
1 READ function READ is possible in
” external sign-al operation ” mode
as well as ” PU operation ” mode.
It is also possible even during operation of motor.
2 WRITE function
WRITE is possible only in ” PU operation ” mode.
It is impossible during operation of motor (setting of
function No.10 (PWM mode) , however, can be changed
during operation of motor) .
3 Selection of READ and WRITE of 3 rd function are possible only
3 rd function
in ” PU operation ” mode.
4
ERROR(Err. >
Error appears when,
display
(11 WRITE is tried during operation of motor, or
(21 entered value is out of the specified range, or
(3) illegal function No. is set, or
(41 WRITE is tried during ” external signal operation ”
mode, or
(51 WRITE is tried while parameter WRITE has been
prohibited (see 9 5. and Q 9 :> .
5.
Clear of ERROR
display
Error condition can be cleared as follows:
(11 Press
[CLEAR] key.
(2) If error is caused by setting illegal function No.
(see 8 9 .> , press m key.
-87-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
