<Setting of buffer memory (BFM)>
BFM Item Set value Note BFM Item Set value Note
#0 Pulse rate 8192 *1 PLS/REV #16
−−
#2, #1 Feed rate 1000
µm/REV
#18, #17
Set position (Ι)
10000 mm
#3
Parameters
b1:1, b0:0
Combined
system
#20, #19
Operating speed (Ι)
50000 Hz
b1, b0 System of units #22, #21
Set position (ΙΙ) −
b5, b4 Position data multiplication b5:1, b4:1 10
3
#24, #23
Operating speed (ΙΙ) −
b8 Pulse output format 0 Forward pulse
#25
Operation command
M0
b9 Rotation direction 0
The current
value increase
b0 Error reset
b10 Home position return direction 0
The current
value decrease
b1 STOP M1
b12 DOG input polarity 0 DOG input ON b2 Forward pulse stop M2
b13 Count start timing 1
Rear end of
DOG input
b3 Reverse pulse stop M3
b14 STOP input polarity 0
Stops because
of turning on
b4 JOG+ M4
b15 STOP input mode 0
The remainder
distance drive
b5 JOG- M5
#5, #4 Maximum speed 50000 b6 Home position return start M6
#6 Bias speed 0 b7 Address b7=1 M7 Relative
#8, #7 JOG speed 10000
b8~
b12
Single speed positioning start
b8=M8
b12~b9
Unused
#10, #9
Home position return speed
(high speed)
10000 #27, #26 Current position D11, D10 mm
#11
Home position return speed
(creep speed)
1500 #28 Status M31~M20
#12
Number of zero point signals for home
position return
10 #29 Error code D20
#14, #13 Home position 0 #30 Model code D12
#15 Acceleration / deceleration time 100 ms #31
−−
*1: This example is described as an example of servo mode by Mitsubishi Electric Corporation amplifier MR-J2.
The value is different according to the connected servo amplifier.
10
FX-1PG/FX
2N
-1PG PULSE GENERATOR UNIT EXAMPLES PROGRAM
10-3
To Next Page
Loading...
Need help?
General