EN-17
B. Plugging in the power cord
In order to ensure the safety in case of trouble with the projector, use an electrical outlet having an earth leakage
breaker to supply the power to the projector. If you do not have such outlet, ask your dealer to install it.
•
The power cords for use in the U.S. and Europe are included with this projector. Use the appropriate one for your
country.
This projector uses the power plug of three-pin grounding type. Do not take away the grounding pin from the
power plug. If the power plug doesn’t fi t your wall outlet, ask an electrician to change the wall outlet.
The provided power cord for the U.S. is rated at 120 V. Never connect this cord to any outlet or power supply
using other voltages or frequencies than rated. If you use a power supply using other voltage than rated, prepare
an appropriate power cord separately.
Use 100-240 V AC 50/60 Hz to prevent fi re or electric shock.
Do not place any objects on the power cord or do not place the projector near heat sources to prevent damage to
the power cord. If the power cord should be damaged, contact your dealer for replacement because it may cause
fi re or electric shock.
Do not modify or alter the power cord. If the power cord is modifi ed or altered, it may cause fi re or electric shock.
Caution:
Plug in the power cord fi rmly. When unplugging, hold and pull the power plug, not the power cord.
Do not plug in or out the power cord with your hand wet. It may cause electric shock.
•
•
•
•
•
•
•
•
Plug the attached power cord into the power cord
inlet of this projector.
Plug the other end of the power cord into a power
outlet.
1.
2.
1
2
Power cord (example)
Earthing
terminal
Viewing video images (continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
