3 ETHERNET INTERFACE MODULE REPLACEMENT
3 - 8
*1 Initial Processing
The Q series performs initial processing by setting the following items in the GX Developer network parameters.
• "Network parameters Setting the number of Ethernet/CC IE/MELSECNET cards"
• "Operational settings"
• "Initial settings"
There is no need for a sequence program for initial processing/end processing.
*2 Communications while the programmable controller CPU is stopped
By setting "Operational settings" - "Initial timing" to "Always wait for OPEN", the Q series can perform communications while
the programmable controller CPU is stopped.
For connections for which passive open and communications during a stop are set to enabled, it is not necessary to use a
sequence program for communications during a stop/open processing/close processing.
*3 Router relay function
The Q series sets the router relay function at "Network parameters" - "router relay parameter" on GX Developer.
There is no need for a sequence program for the router relay function.
To Next Page
Loading...
