3 ETHERNET INTERFACE MODULE REPLACEMENT
3 - 11
*2 Communications while the programmable controller CPU is stopped
By setting "Operational settings" - "Initial timing" to "Always wait for OPEN", the Q series can perform communications while
the programmable controller CPU is stopped.
For connections for which passive open and communications during a stop are set to enabled, it is not necessary to use a
sequence program for communications during a stop/open processing/close processing.
*3 MELSECNET/H, MELSECNET/10 relay exchange
On the Q series, Ethernet parameters (network number and station number) using the EPRSET instruction cannot be set.
When the EPRSET instruction is in use, delete the sequence program of the corresponding section, and set the Ethernet
parameters in the GX Developer network parameters.
*4 Communications using pairing open
On the Q series, the pairing open setting of connection No.8 is not possible.
(Connection No.8 is pairing for reception, and connection No.1 is pairing for transmission.)
When the pairing open setting of connection No.8 has been made, change the sequence program.
On the Q series, the pairing open settings of connection No.1 to 7, and 9 to 15 are possible.