9
3-13 Installation of the thread stand
(1) Assemble the thread stand with the
instructions enclosed in the packing.
(2) Fit the thread stand (NO.1) in the thread
stand hole on the tabletop.
(3) Fix the thread stand (NO.1) firmly from the
rear side of the table with tightening the nut
(NO.4) and the washers (NO.2, 3).
3-14 Functioning the work holder pedal
(1) Connect the chain (NO.1) across the
lever (NO.2) located at the left side of the
sewing machine head and the work
holder pedal mounted on the steel stand
bottom beam. The chain (NO.1) is
enclosed in the accessory box.
(2) Put the stepping motor cover (NO.4) back
on the sewing machine head with the
screw (NO.5) after the chain (NO.1)
connection.
1
2
3
4
4
5
2
1
3
To Next Page
Loading...
