Mitsubishi Q12PRHCPU - 6.1 Communication with GX Developer and PX Developer

6 - 1
6.1 Communication with GX Developer and PX Developer
6.1.1 Communication Methods with GX Developer
6
REDUNDANT SYSTEM NETWORKS
CHAPTER6 REDUNDANT SYSTEM NETWORKS
This chapter explains the redundant system networks on the assumption that the
operation mode has been set to backup mode.
6.1 Communication with GX Developer and PX Developer
6.1.1 Communication Methods with GX Developer
The communication between GX Developer and redundant CPU module can be made
through the following three paths.
• CPU module direct connection
• Routing a network module
• Routing an intelligent function module
In the case of GX Developer, select [Online] - [Specify Connection] from the menu bar, and
specify the connection path on the displayed dialog box.
And, specify the communication target system from the following: "Not specified" (default),
"Control system", "Standby system", "System A" and "System B". ( Table6.1)
Diagram 6.1 Connection Setup Screen
Specify a
destination
system