5
REDUNDANT SYSTEM FUNCTIONS
5.1 Basic Concept of Redundant System
5.1.3 Operation Mode
5 - 14
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
TRACKING CABLE
4
PROCEDURE FOR
STARTING UP A
REDUNDANT SYSTEM
5
REDUNDANT SYSTEM
FUNCTIONS
6
REDUNDANT SYSTEM
NETWORKS
7
PROGRAMMING
CAUTIONS
8
TROUBLESHOOTING
(a) Setting and Canceling the Debug Mode
The debug mode must be specified in the redundant parameter settings with GX
Developer to operate the system in the debug mode .
1) Write the redundant parameter in which "Start with Debug mode" is set into the
CPU module, and power on the system again or set the RESET/L.CLR switch
of the CPU module to reset switch neutral position. Then, the system will start
up in the debug mode.
2) Write the redundant parameter in which "Do not start with Debug mode" is set
into the CPU module, and power on the system again or set the RESET/L.CLR
switch of the CPU module to reset switch neutral position. Then, the system
will start up in the operation mode other than debug mode.
Diagram 5.9 Setting of Debug Mode on Redundant Parameter Screen
System A -
Control
System
GX Developer
3) Reset the CPU module
4) Debugging standalone system
1) Debug Mode Setting
2) Write parameters to the
CPU module.
Select "Start with Debug
Mode."
To Next Page
Loading...
