Mitsubishi QD75P1N - Page 177

5 - 73
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Da.14
Parameter
Set the value as required for "
Da.13
Special start instruction ".
Da.13
Special start instruction
Setting value Setting details
Block start (Normal start) – Not used. (There is no need to set.)
Condition start
Wait start
Simultaneous start
1 to 10
Set the condition data No. (No. of
"condition data" set to perform
condition judgment)
(For details of the condition data, refer
to Section 5.5.)
Repeated start (FOR loop) 0 to 255 Set the No. of repetitions.
Repeated start (FOR condition) 1 to 10
Set the condition data No. (No. of
"condition data" set to perform
condition judgment)
(For details of the condition data, refer
to Section 5.5.)