Mitsubishi QD75P1N - Flow of System Operation; Flow of All Processes

1 - 15
MELSEC-Q
1 PRODUCT OUTLINE
1.2 Flow of system operation
1.2.1 Flow of all processes
The positioning control processes, using the QD75, are shown below.
GX Configurator-QP
Servo, etc.
QD75
GX Developer
Design
Understand the functions and performance, and determine the positioning operation method
(system design)
1)
Preparation
Installation, wiring
Setting of the:
Refer to (Note)
2)
3) 4)
5) 6)
7) 8)
Writing of setting data
Connection confirmation
Test operation
9)
10)
11)
Operation
Monitor
Actual operation
Maintenance
Monitor
Disposal
(Note)
Maintenance
CPU module
• Parameters
• Positioning data
• Block start data
• Condition data
Monitoring with
test operation,
and debugging
of setting data
Creation of sequence
program for operation
Writing of program
Monitoring and
debugging of
operation
program
When not using
GX Configurator
-QP, carry out
setting, monitoring
and debugging of
the data in 3) with
GX Developer.