Mitsubishi QD75P1N - Page 213

5 - 109
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Storage buffer
memory address
Setting value
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Set with a decimal.
Setting
v
alue
Positioning data No.
1 to 600
7000 to7004
9001
9002
9003
9004
K
: Positioning data No.
: Block start designation
: Machine OPR
: Fast-OPR
: Current value changing
: Simultaneous starting of multiple axes
0 1500 1600 1700 1800
Set with a decimal.
Setting
value
K
1 to 50
Positioning starting point No.
0 1501 1601 1701 1801
Set with a decimal.
K
1
Error reset request
S
etting value
A
fter the axis error reset is completed, "0" is stored by the QD75 automatically.
(
Indicates that the axis error reset is com
p
leted.
)
1: Axis error is reset.
0 1502 1602 1702 1802
Set with a decimal.
K
1
Restart command
Setting value
After restart acceptance is completed, "0" is stored by the QD75 automatically.
(Indicates that the restart acceptance is completed.)
1: Restarts
0 1503 1603 1703 1803
Set with a decimal.
K
1
M code OFF request
Setting value
After the M code ON signal turns OFF, "0" is stored by the QD75 automatically.
(
Indicates that the OFF re
q
uest is com
p
leted.
)
1: M code ON signal turns OFF
0 1504 1604 1704 1804