Mitsubishi QD75P1N - Page 245

6 - 13
MELSEC-Q
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
No.7
No.8
No.9
Continued from previous page
Start details setting program
Refer to Section 6.5.2
Positioning start No.
setting program
Start program
Positioning start program
Refer to Section 6.5.3
Program to reset the start
signal and turn the M code
ON signal OFF
M code OFF program
JOG operation program
No.10
No.12
JOG operation program
Refer to Section 11.2.4
Inching operation program
No.11
No.12
Inching operation program
Refer to Section 11.3.4
Manual pulse generator
operation program
No.13
Manual pulse generator
operation program
Refer to Section 11.4.4
Continued on next page
Program required to carry out
 "OPR control"
 "Major positioning control"
 "High-level positioning control"
Program required to carry out
"manual control"