10 - 13
MELSEC-Q
10 HIGH-LEVEL POSITIONING CONTROL
[3] Precautions
Positioning data No. executed by simultaneously started axes is set to condition
data ("
Da.18
Parameter 1","
Da.19
Parameter 2", but the setting value of start
axis (the axis which carries out positioning start) should be "0". If the setting value
is set to other than "0", the positioning data set in "
Da.18
Parameter 1",
"
Da.19
Parameter 2" is given priority to be executed rather than "
Da.12
Start
data No.".
(For details, refer to section 5.5 "List of condition data".)
To Next Page
Loading...
