14 - 15
MELSEC-Q
14 DEDICATED INSTRUCTIONS
[Program example]
Program to execute the teaching of the positioning data No. 3 of the axis 1 when
X39 is turned ON.
(1) Teaching program
Positioning is carried out for a target position by manual operation.
<Teaching command pulse>
<Teaching command hold>
<Teaching data setting>
<Positioning data No. setting>
<Teaching execution>
<Teaching command storage OFF>
(2) Teaching program (when the dedicated instruction is not used)
Positioning is carried out for a target position by manual operation.
<Teaching command pulse>
<Teaching command hold>
<Teaching positioning address>
<Sets teaching positioning data No. to 1>
<Turns OFF teaching command storage>
To Next Page
Loading...
