Mitsubishi QD75P1N - Page 637

14 - 23
MELSEC-Q
14 DEDICATED INSTRUCTIONS
[Program example]
The following program initializes the parameters in buffer memory and flash ROM
when X3C turns ON.
(1) Parameter initialization program
<Parameter initialization command pulse>
<Parameter initialization command hold>
<PLC READY output to QD75 standby>
<Parameter initialization execution>
<Parameter initialization command storage OFF>
(2) Parameter initialization program (when the dedicated instruction is not used)
<Parameter initialization command pulse>
<Parameter initialization command hold>
<PLC READY output to QD75 standby>
<Parameter initialization execution>
<Parameter initialization
command storage OFF>