Mitsubishi QD75P1N - Page 663

15 - 25
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with sequence program)
Remedy
Command speed storage
addresses of positioning
data No. 1 to 600
<Command speed>
QD75P
N/QD75D N:
1 to 4000000 [pulse/s]
1 to 2000000000
[
×
10
-2
mm/min or others]
QD75P /QD75D :
1 to 1000000 [pulse/s]
1 to 2000000000
[
×
10
-2
mm/min or others]
Correct the command speed.
(Refer to Section 5.3
Da.8
)
29 179 329 479
<Interpolation speed designation
method>
0: Composite speed
1: Reference axis speed
Set the "Interpolation speed designation method"
correctly.
(Refer to Section 9.1.6)
Same as error codes 515 to 516
• Correct the control system axis to be interpolated, or
parameter.
(Refer to Section 9.1.6, 9.2.20)
• Do not make setting at buffer memory address 1906
(use prohibited area).
Refer to Section 5.3
"List of positioning data"
<Positioning address/movement
amount>
• unit [mm] [pulse] [inch]
–2147483648 to 2147483647
(Unit [degree] cannot be set.)
<Arc address>
–2147483648 to 2147483647
Correct the sub address (arc address).
(Refer to Section 9.2.10)