MODEL NAME
Mitsubishi Diesel Engine S12R OPERATION & MAINTENANCE MANUAL
11
Pub. No. 291Y1-40720 Revision: 5
MODEL NAME
In this manual, different models of the same series
are described. Please check the model name and
other details with the nameplate on this engine, and
fill in "
SPECIFICATIONS - CHECK" (→ Page 12).
■ Location of Nameplate
The nameplate is located on the lateral side of the
engine, and indicates the following information:
• Serial number
• Manufactured date
• Model name
• Rated output
• Rated speed
<Engine Top View>
Fig. 1 Location of Nameplate
EMISSION CONTROL
APPROVED LABEL
The emission control approved label is attached on
the model obtained a certificate of conformity to
EPA or CARB regulations of USA.
When handling the label, you have to take care that
the label will not get dirty or peeled off. Otherwise,
the label may become impossible to prove the
exhaust gas performance, and result in a violation
of the laws and regulations.
In case that the label gets dirty or peeled off, the
label must be stored as it is, and you must
immediately contact your MHIET dealer
"
CONTACT LIST" (→ Page 10).
■ Location of Emission Control
Approved Label
The emission control approved label is attached on
the location below.
Fig. 2 Attaching location of Emission Control
Approved Label
12
654321
11 10 9 8 7
Left Side
Rear
Side
Front
Side
Right Side
Cylinder No.
*Above illustration shows S12R nameplate.
Emission Control
Approved Label
Attaching Direction
Up
To Next Page
Loading...
