Mitsubishi S12R - UNIT OF MEASUREMENT; ABBREVIATIONS AND STANDARDS

UNIT OF MEASUREMENT
Mitsubishi Diesel Engine S12R OPERATION & MAINTENANCE MANUAL
20
Pub. No. 291Y1-40720 Revision: 5
UNIT OF MEASUREMENT
In this manual, the SI System (International Unit System) is basically used for the units of measurement. The
conversion rates between the SI system and other conventional systems are given below.
[Pressure] 1 MPa = 10.197 kgf/cm
2
[Torque] 1 Nꞏm = 0.10197 kgfꞏm
[Force] 1 N = 0.10197kgf
[Horsepower] 1 kW = 1.341 HP = 1.3596 PS
[Pressure (meter of mercury)] 1 kPa = 0.75 cmHg
[Pressure (meter of water)] 1 kPa = 10.197 cmH
2
O (cmAq)
[Rotating speed] 1 min
-1
= 1 rpm
[Kinetic viscosity] 1 mm
2
/s = 1 cSt
ABBREVIATIONS AND STANDARDS
• API = American Petroleum Institute
• ASTM = ASTM International
• CARB = California Air Resources Board
• CCS = Cold Cranking Simulator
• EPA = United States Environmental Protection Agency
• FED = Federal Specifications and Standards
• ISO = International Organization for Standardization
• JIS = Japanese Industrial Standards
• JPI = Japan Petroleum Institute
• LLC = Long Life Coolant
• MHIET = Mitsubishi Heavy Industries Engine & Turbocharger, Ltd.
• MRV = Mini - Rotary Viscometer
• OSHA = Occupational Safety and Health Administration
• SAE = Society of Automotive Engineers
• SDS = Safety Data Sheet