Mitsubishi S12R - Page 143

8 INSPECTION AND MAINTENANCE
Mitsubishi Diesel Engine S12R OPERATION & MAINTENANCE MANUAL
143
Pub. No. 291Y1-40720 Revision: 5
2 Push the manual stop lever to the
fuel increase direction and hold this
position.
Fig. 8-39 Manual Stop Lever - Operate
• The location of the manual stop lever
varies depending on the specification
of the engine. Refer to "
Protection
System - Location" (→ Page 82).
3 Decrease the pushing pressure little
by little, and check the manual stop
lever for smooth returning to the
previous position.
Fig. 8-40 Manual Stop Lever - Check
• If the lever cannot be returned back
smoothly, contact your MHIET dealer
"
CONTACT LIST" (→ Page 10).
4 Check the ball joint (1) for looseness
of 0.1 mm [0.004 in.] or more.
Fig. 8-41 Ball Joint - Check
• If looseness is detected, replace the
ball joint with a new one. "
Ball Joint -
Replace" (→ Page 144)
• If the sealing is defective, contact
your MHIET dealer "
CONTACT LIST"
(→ Page 10).
䣕䣖䣑䣒
䣕䣖䣑䣒䣕䣖䣑䣒
䣕䣖䣑䣒
䣕䣖䣑䣒
(1) (1)
0.1 mm [0.004 in.]
0.1 mm
[0.004 in.]