9-1
LUBRICATION SYSTEM
1. Removing lubrication system ..........9-2
1.1 Removing and inspecting oil cooler and relief
valve......................................................... 9-2
1.2 Removing and inspecting oil pan, oil pump,
oil pressure switch ................................... 9-3
1.3 Removing and inspecting oil pipe and oil
separator.................................................. 9-4
2. Disassembling, inspecting and
reassembling lubrication system.....9-5
2.1 Disassembling and inspecting oil pump... 9-5
2.2 Measuring clearance between outer rotor and
inner rotor................................................. 9-5
2.3 Measuring end play of rotor and
pump case ............................................... 9-6
2.4 Measuring clearance between outor rotor and
pump case ............................................... 9-6
2.5 Reassembling oil pump............................ 9-6
2.6 Inspecting relief valve .............................. 9-6
3. Installing lubrication system ............9-7
3.1 Installing oil pan, oil pump and oil pressure
switch....................................................... 9-7
3.2 Installing oil cooler and relief valve .......... 9-8
3.3 Installing oil pipe and oil separator........... 9-9
To Next Page
Loading...
