REASSEMBLY OF BASIC ENGINE
7-3
1.4 Installing main bearing cap
&$87,21
The foremost and rearmost caps should be installed
so that they are flush with the crankcase surface.
Install the main bearing caps so that their front marks
(arrow) and cap numbers are in numerical order from the
front of the engine.
Installing main bearing cap
1.5 Installing main bearing cap bolt
(1)
Tighten the main bearing cap bolts alternately and
progressively to the specified torque.
(2) Make sure that the crankshaft rotates smoothly.
Installing main bearing cap bolt
Inspecting crankshaft for rotation
12 3
5
Engine
front side
Front mark
Cap No.
Surfaces
must flush
Surfaces
must flush
83 ± 5 N·m
{8.5 ± 0.5 kgf·m}
[61 ± 3.6 lbf·ft]
To Next Page
Loading...
