Mitutoyo ABSOLUTE ID-F0550ENX - Measurement Mode and Parameter Setting Mode; Measurement Mode; Parameter Setting Mode

20
3 Basic Usage
No. 99MAH054A
(Short press) / (Long press)
3.4
Measurement Mode and Parameter Setting Mode
This product has two modes: measurement mode and parameter setting mode.
3.4.1 Measurement Mode
This mode is used for tasks such as normal measurement, calculation
measurement, tolerance judgment, holding displayed values, and outputting
displayed values to an external device.
When in measurement mode, three methods for displaying measurement values
are available for selection.
Displayed contents
Standard 1,
Standard 2
Directly displays the measured value to be displaced.
• Standard 1: (Key customizable)
• Standard 2: (Key not customizable)
For details on customization, see
"4.6 Customizing
Keys" on page 33.
Peak detection Holds and displays the peak value of the measured
value to be displaced.
For details about peak detection, see
"4.3 Peak
Detection" on page 28.
3.4.2 Parameter Setting Mode
This mode is used to set parameters. For details, see "5 Setting Parameters"
on page 37.