Mitutoyo ABSOLUTE ID-F0550ENX - Change Other Functions; Selecting Setting Items; Calibration Schedule Warning Selection;Setting

62
5 Setting Parameters
No. 99MAH054A
(Short press) / (Long press)
5.11
Change Other Functions
5.11.1 Selecting Setting Items
There are three types of parameter items in "Change other functions".
"5.11.2 Calibration Schedule
Warning Selection/Setting" on
page 62
"5.11.3 Selecting Digimatic Output"
on page 67
"5.11.4 All Reset" on page 68
F1
F1
F3
F3
F2
F2
F2
F1
F1
F3
F2
5.11. 2 Calibration Schedule Warning Selection/Setting
By setting the current date, calibration date and advance warning date, the
warning display (
) notifying the arrival of calibration schedule will blink/be lit on
the display.
y When the current date is between
the advance warning date and the
calibration date: The warning display
will blink
y When the current date is after than
the calibration date: The entire
display will be lit (warning display
is lit)