Mitutoyo QM-Height QMH-14"AX - Display Unit Functions

5
1 Before Using This Product
No. 99MAF600B
Number Name Functions
①
Tolerance
judgment
results LED
LED lamp that indicates the result of the tolerance judgment. For details,
see "3.2 Judging the Tolerance" on page 40.
②
[Power button] Turnsthepoweronoro󰀨.
③
[Inside diameter
measurement]
Measures the inside diameter. For details, see
"2.4 Measuring the
Inside Diameter" on page 24.
④
[Outside diameter
measurement]
Measures the outside diameter. For details, see
"2.5 Measuring the
Outside Diameter" on page 27.
⑤
[Scanning
measurement]
Measures the maximum run-out, minimum run-out, and displacement
value(maximum–minimum)ofaatsurface.
For details, see
"2.6 Measuring the Plane Displacement (Plane
Scanning Measurement)" on page 30.
⑥
[ZERO/ABS] Switches between the ABS measurement system and the INC measure-
ment system (simultaneously sets the display to zero).
⑦
[in/mm] Changes the setting for units between inches and millimeters (only on
models that support inches).
⑧
[PRESET] Presets a value for the point of measurement.
⑨
[↑]
[→]
[↓]
[←]
[ENTER]
y Changes numbers and settings. Press [ENTER]toconrmanoperation.
y Press and hold [↓] to change the counting direction. Moving the probe
unit upwards decreases the counter value, and moving the probe unit
downwards increases the counter value.
Press and hold the button again to return to normal.
If you have changed the counting direction, follow " 2.1.1 Setting
the Origin and the Reference" on page 12 to set the origin again.
⑩
[CANCEL] Cancels a key operation.
Pressed to cancel items such as outside diameter measurements that
have been selected with key operations or measurements that are being
processed.
⑪
[MODE] Usedtoconguresettingsforaspecicapplication,suchaschanging
the measurement resolution.
For details, see
"3SpecicUsageApplications"onpage33.
⑫
[HOLD DATA] Holds the display of a measurement value or outputs the measurement
results to external devices.
For details about outputting data to external devices, see
"3.8 Out-
putting Measurement Results to an External Device" on page 52.