Mitutoyo QM-Height QMH-14"AX - Basic Measuring Methods; Preparing Measurements; Setting the Diameter of the Ball

11
No. 99MAF600B
2 Basic Measuring Methods
2
2 Basic Measuring Methods
Using the following workpiece as an example, measurement preparations and the height, width, inside
diameter, outside diameter, and plane displacement measuring methods will be explained.
Tips
Videosaboutmeasurementpreparationsandmea-
surement methods can be viewed from the following
QRcodesorwith[►].
2.1 Preparing Measurements
2.1.1 Setting the Origin and the
Reference
●Settingthesurfaceplateas
the origin
page 12
●Settingapositionotherthan
the surface plate as the origin
page 14
■Settingthereference
(INC measurement system)
page 16
2.1.2 Setting the Diameter of the
Ball
page 18
Basic Measuring Methods
2.2 Measuring the Height 2.4 Measuring the Inside Diame-
ter (Manual Termination)
page 21 page 26
2.3 Measuring Steps and Width
(Step Measurements)
2.5 Measuring the Outside Diame-
ter (Automatic Termination)
page 22 page 27
2.3 Measuring Steps and Width
(Width Measurements)
2.5 Measuring the Outside Diame-
ter (Manual Termination)
page 22 page 29
2.4 Measuring the Inside Diame-
ter (Automatic Termination)
2.6 Measuring the Plane Dis-
placement (Plane Scanning
Measurement)
page 24 page 30