Mitutoyo QM-Height QMH-14"AX - Measuring Steps and Width

22
2 Basic Measuring Methods
No. 99MAF600B
2.3 Measuring Steps and Width
Measure steps or width.
This section explains the measurement procedure using surface s1 as the reference (INC measurement
system).
s2
s1 (0 mm)
s1 (0 mm)
s2
Groove width measurementStep measurement
1
Set surface s1 as the reference (INC measurement system).
For details about the setup, see "2.1.1 Setting the Origin and the Reference" on page 12.
2
Turn the probe unit up/down wheel, and slowly bring the stylus into contact with surface s1
until there is a "beep" sound.
y For step measurements
s1 (0 mm)
» [0.000] will be displayed on the LCD.
y For groove width measurements
s1 (0 mm)
» [0.000] will be displayed on the LCD.
A video about step measure-
ments can be viewed.
A video about measuring the
width can be viewed.