Mitutoyo QM-Height QMH-14"AX - Setting Surface Plate as Origin (ABS)

13
2 Basic Measuring Methods
No. 99MAF600B
■Setting the origin (ABS measurement system)
●
Setting the surface plate as the origin
1
Press [PRESET].
» The preset value from the previous occasion is displayed
(initial value: +000.000).
2
Check that [+000.000] is displayed on the LCD.
Ifadi󰀨erentvalueisdisplayed,setitto
[+000.000].Fordetailsaboutconguringthe
settings, see "●Settingapositionother
than the surface plate as the origin" on page
14.
3
Set the origin.
1 Loosen the clamp knob.
2 Loosen the clamp screw.
3 Turn the probe unit up/down wheel, and slowly bring the stylus into contact with the surface plate until there
is a "beep" sound.
1
2
3
3
» The origin will be set, and
the height relative to the set
origin will be displayed in the
top row of the display.
4
Conrmthesetorigin.
1 Slowly move the stylus away from the surface plate, and bring them into contact again by turning the probe
unit up/down wheel until a "beep" sound is made.
2 Check that [0.000] is displayed on the LCD (the origin setup is complete).
Tips
Iftheoriginissignicantlydi󰀨erentfrom[0.000],performsteps 1 through 4 again.
A video about the setup can
be viewed.