Mitutoyo QM-Height QMH-14"AX - Judging the Tolerance

31
2 Basic Measuring Methods
No. 99MAF600B
4 While keeping the probe unit up/down wheel
stationary, move the workpiece or the main
unit to scan the surface of the workpiece.
» The counter value will
change according to the
scanning movement.
Tips
• When both the highest and lowest points are detected, the value that is displayed on the LCD will be held.
• Iftheprobeunitup/downwheelisdi󰀩culttosecure,tightentheclampscrew.
5 Press [ENTER]. » The scanning measurement
is complete, and displace-
ment A (1.000 mm) will be
displayed.
It will be automatically out-
put at the same time to the
connected external device.
3
Press [↑]or[↓]tocheckthemeasurementresult.
» For each key press, the counter value will switch among
[displacement (W)], [minimum (ZS)], and [maximum
(ZL)].
Tips
Thedi󰀨erencebetweenthemediandisplacementvalueandthepreviousmeasurementvaluewillbedisplayedin
the bottom row of the LCD.