Page 34
The use of an RTA is the easiest way to confirm proper channel
combination(s) thru a mixer. This technique can give you a quick
visual indication of the signal frequency response, using pink noise as
the source signal and connecting the DSP8 output to the RTA line
level input. While it is possible to do everything by ear, an RTA will
make this part of the setup and tuning process much faster and
easier.
Operating the Mixer-
Operation and Adjustment of the mixer settings can be done thru
tree different tasks depending on which will suit your personal and
application needs the best.
1) Double click on the numerical channel entry on the right
hand side of the user utility will allow you to cycle the value of
the individual adjustment between Off (-100) and On (0).
2) Manually enter the value of the desired adjustment in the
individual channels numerical value window readout on the
right hand side of the user utility
3) Use your mouse by hovering over the desired dial represent-
ing the channel you wish to make adjustment on and rotate
the dial to the desired value.
To Next Page
Loading...
Need help?
General
