Need help?Do you have a question about the µ-Dimension Glow DSP8 and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| DSP | Yes |
| RMS Power Output (4 Ohms) | 75W x 8 |
| RMS Power Output (2 Ohms) | 100W x 8 |
| Bridged RMS Power Output (4 Ohms) | 200W x 4 |
| Frequency Response | 10 Hz - 22 kHz |
| Signal-to-Noise Ratio | >100 dB |
| Total Harmonic Distortion (THD) | <0.05% |
| Crossover Frequency Range | 20 Hz - 20 kHz |
Critical steps for proper system grounding to prevent noise.
Identifies and describes the unit's various ports and connections.
Details the function and configuration of internal jumpers.
Describes the main input connector and its capabilities.
How to connect speaker-level signals from factory radios.
Explains Send, Retrieve, and Offline sync modes for PC and DSP.
Managing custom tuning files on PC for backup and reuse.
Procedure to set up password protection for the DSP8.
Steps to reset the DSP8 to its original factory state.
Step-by-step guide for updating the unit's firmware.
Essential precautions to avoid update failure or damage.
Procedure for installing the USB boot loader driver.
Choosing the appropriate folder containing the drivers.
Granting permission for the driver software installation.
Optimizing signal levels for best system performance and clarity.
Recombining signals and creating custom mixes for channels.
Setting initial input mixer levels and polarity.
Adjusting output levels using appropriate test tones.
Setting EQ for aftermarket and OE sources to neutralize factory EQ.
Basic crossover configuration for speaker protection.
Setting initial delay based on speaker distance for time alignment.
Using listening for precise delay adjustments and optimal soundstage.
Solutions for when the DSP8 does not turn on.
Troubleshooting steps for when there is no sound output.
Ensuring PC and DSP settings align correctly.
Resolving issues with PC connection to the DSP8.
Fixing USB connection problems during firmware updates.
To Next Page
