30
MK-2000 ELECTRIC SAW MAINTENANCE
(A)
Turn OFF saw and unplug. Re-
move the Blade.
(B)
Remove the two Belt Guard
Retaining Screws and the Belt
Guard using a 1/2-inch wrench
and rotate counter-clockwise to
loosen. Remove Belt Guard.
BELT INSPECTION, ADJUSTMENT & REPLACEMENT
The MK-2000 is designed with a power transmission belt. In order to ensure the MK-2000 operates at
peak efciency, the belt should be inspected monthly, and changed if the belt shows damage and/or
excessive wear.
(C)
Inspect the belt for cracks, fray-
ing, separation and wear.
NOTE: When a new belt is installed, it should be inspected and re-tensioned after the
rst forty-eight (48) hours of operation.
To Next Page
Loading...
