MKS HPQ3 - Adding the HPQ3

MKS Instruments UK Ltd
HPQ3 Hardware Manual – SP101019.101 October 2012
33
Do not continue until you are certain of your network configuration
The following sections describe the different network connection options available to the user when
installing the HPQ3 RGA.
5.1 Adding the HPQ3 to an existing network
The HPQ3 is to be connected to a network running Auto-IP or DHCP
Option - Use Auto-IP
If the HPQ3 is to be connected to a network where existing devices obtain their IP address
automatically, then no further configuration is required.
You can safely connect the HPQ3 to your network.
The HPQ3 is to be connected to a network running BOOTP
Option - Use Auto-IP
If the HPQ3 is to be connected to a network running BOOTP, then your IT Specialist will need to
perform certain tasks on the BOOTP Server to complete the installation.
Do not connect the HPQ3 to your network without involving your IT specialist.
The HPQ3 is to be connected to a network using Static IP addressing
See the Static IP Addressing section