MO-SYS StarTracker Max - Page 41

To reset lens ranges, press the Zero lens button on the processor. The button is recessed and
you need a thin pin tool to press it (e.g. toothpick, sharp pencil. smallest Allen key from the tool
kit.
After this you need to show the lens ranges, moving the zoom and focus lens rings to their
physical end-stops a couple of times.
10.3 Digital Lens Encoding
Mo-Sys o󰍒ers Digi Lens interface for most Fujinon and Canon ENG type lenses. If your lens servo
has a port that says "Virtual" it is compatible. But if in doubt please contact us.
StarTracker Max Manual
2023 - 2024 © Mo-Sys Engineering Ltd. All rights reserved 41 of 70