MO-SYS StarTracker Max - Page 42

Note: When using Digi Lens make sure that the camera and lens is powered on before you
power on the StarTracker. If the lens has no power StarTracker software will show an “I/O error”.
To 󰍓x it, check there is power to the camera and lens and do a complete power reboot of the
StarTracker. A restart of the processor using the power button alone will not solve the problem.
A complete power cycle (unplug PSU, wait 30 seconds and plug it back in) is required.
StarTracker Max Manual
2023 - 2024 © Mo-Sys Engineering Ltd. All rights reserved 42 of 70