MO-SYS StarTracker Max

To Next Page

To Previous Page

12.4 Observation of Points

Create a crosshair in the centre of your studio camera image to help you with the observation

phase. Most cameras or virtual set software allow you to create a crosshair in the centre of the

image.

Start by looking at point 1 through the studio camera, aligning it in the centre of image. If you

are using the Auto-Align kit center the tip of the cone. The closer to the centre of the image you

are when you add the observation the better the calibration will be. You do not need to observe

StarTracker Max Manual

MO-SYS StarTracker Max - Page 51