Go back by clicking Output.
Put the IP of your virtual set engine into Destination IP 1 eld.
The Protocol button next to Send UDP allows you to select the protocol to either (Mo-Sys) F4, D1
(freed) or PSN (Posi Stage Net).
Use the second and third “Destination IP” row if you need to send the tracking data to two
dierent engines. You can send to a dierent IP and port and also send the data in a dierent
format (e.g., F4 and D1).
Put the IP of your virtual set engine into Destination IP 1 eld.
The Protocol button next to Send UDP allows you to select the protocol to either (Mo-Sys) F4 or
D1 (freed).
When you enable LED mode, the data will be sent with lower latency and other settings are
applied to optimise use within LED volumes.
Use the second and third “Destination IP” row if you need to send the tracking data to two
dierent engines. You can send to a dierent IP and port and send the data in a dierent format
(e.g., F4 and D1).
StarTracker versions later than 1310M have a Ping Test option in the Network menu. Pressing
this button will automatically ping the target IP set in the Data → UDP Out menu and return
either OK or FAIL. Wait up to 10 seconds for the test to complete.
Failure indicates an inability to ping the target machine (no route or response), indicating the
tracking UDP packets are unlikely to reach the target machine. In this case, check:
Is Windows rewall enabled on the target machine? This can block UDP packets from the
StarTracker
Have you set the IP settings of the target computer correctly?
Are the IP/netmask settings for the StarTracker and UDP target compatible?
14.2 F4 Lens Data
If you are using a Mo-Sys Lens File, make sure you enable it either in Data → F4 Lens or in Data
→ Lens Data → Enable (same button)
To load a lens le, go to Data → Lens Data → Load File.
Select the lens le from a list, type the number and hit enter.
•
•
•
StarTracker Max Manual
2023 - 2024 © Mo-Sys Engineering Ltd. All rights reserved 61 of 70
To Next Page
Loading...
