Page 4 of 46
14. Do not use strong detergents or alcohol under any circumstances for optics
cleaning. This would lead to irrevocable damage to the optically-coated
lens surfaces.
15. To limit contamination, use recommended disinfectant agents between
each exam.
16. Do not use corrosive materials or strong cleaning materials other than
those specifically prescribed on the casings or on the optics. Such materials
lead to permanent damage of the painted surface of your colposcope
and/or scratch the lens coatings of the optics. This leads to considerable
loss of quality of the entire visual system.
17. If the LED light ceases to work, due to battery drain or LED burn out, stop
using the colposcope and recharge the batteries. Sometimes a discharged
battery will manifest via a flickering LED. In this case, recharge the battery
to full capacity before continuing use.
18. FCC CAUTION: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
a. This device may not cause harmful interference; and
b. This device must accept any interference received, including
interference that may cause undesired operation.
19. This product complies with the US portable RF exposure limit set forth for
an uncontrolled environment and is safe for intended operation as
described in this manual. Further RF exposure reduction can be achieved if
the product is kept as far as possible from the user body or is set to a lower
output power if such function is available. This transmitter must not be co-
located or operated in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following
condition:
a. The transmitter module may not be co-located with any other
transmitter or antenna;
b. If the condition above is met, further transmitter testing is not
required. However, the OEM integrator is still responsible for testing
their end-Product for any additional compliance requirements
required with this installed module.
20. Per AAMI TIR69:2017, the risk associated with this device is assessed as
Category D NEGLIGIBLE for wireless QoS needed for safe and effective
operation.
To Next Page
Loading...
