Mobileye 5 - External Fuse Holder & 2 A Fuse; Eyewatch - Display & Control Unit Connection (Optional); Eyecan - Mobileye CAN to USB Interface

Technical Support
Mobileye 5 – Technical Installation Guide_Rev 0.3
Jan, 2012
Page 11 of 38
Mobileye Proprietary and Confidential
support@mobileye.com
2.2.2 External Fuse Holder & 2A Fuse
The External Fuse Holder connection is as follows
1. Cut the fuse holder cable so that it creates 2 separate wires
2. Connect one end of the Fuse holder to the Vehicle Power source (12V/24V).
3. Connect one end of the Fuse wire to the Mobileye Power Cable (Red wire).
2.2.3 EyeWatch – Display & Control unit connection (optional)
The EyeWatch is supplied only on certain Mobileye 5 models. The EyeWatch is
connected to the Mobileye 5 EyeWatch Female connector (J1) using the EyeWatch
connecting cable Male connector (J1).
Wire Name
Wire color
Connector
Connection To
EyeWatch Cable (CAB000087)
Black
J1 - male
Mobileye 5 cable - EyeWatch connector
EyeWatch - (CAB000105)
Black
J1- female
EyeWatch Display & Control unit
Table 2: EyeWatch connections
2.2.4 EyeCAN – Mobileye CAN to USB interface
The EyeCAN is NOT part of the Mobileye 5 system. It is a tool which enables the
installer to configure and calibrate the Mobileye 5 system during the installation. The
Mobileye 5 EyeCAN Male connector (P2) is used for connection with the Mobileye
EyeCAN Box Female connector labeled “CAN” (J5).
Wire Name
Wire color
Connector
Connection To
CAN (EyeCAN box connector)
Black
J5 - female
Mobileye 5 cable - EyeCAN connector
EyeCAN - (CAB000105)
Black
J1- Male
EyeCAN box connector labeled “CAN”
Table 3: EyeCAN connections