Mobileye 5 - Signals Source

Technical Support
Mobileye 5 – Technical Installation Guide_Rev 0.3
Jan, 2012
Page 31 of 38
Mobileye Proprietary and Confidential
support@mobileye.com
4.3.5 Signals Source
- The Signal source slide informs you about the source of each signal.
- In Mobileye 5 the Signal Source will always be “CAN”
- Mobileye 5 cannot be configured to work with the vehicle’s Analog signals.
- CAN-Bus signals cannot be configured back to work with an Analog connection.
- A vehicle must be chosen from the CAN Database using the “Digital signals form”.
- Signals not available by CAN will be disabled.
- It is recommended not to make any changes if you followed the instructions in the
Digital signals form” (CAN installation).
When done, click “Next”