Tethys D60 - Tethys T60 - Tethys T45 SHORT-FORM MANUAL
6.3 REUSING THE APPLIANCE AFTER A PERIOD OUT OF USE
If the appliance has been unused for a long time, before starting a cycle, follow these recommendations.
Inspect the filters at the ends of the water intake hoses and check that no sludge or rust has deposited in the pipelines; if this
has occurred, allow water to run from the water supply tap for a few minutes.
Restore the electricity supply (if disconnected).
Reconnect the water supply hose and turn on the tap.
Run PROGRAM 1, or another program with a thermal disinfection, with no load for processing.
A thermal disinfection cycle should be performed before using the appliance if it has been out of use for 24 hours or
more.
WARNING: after 24 hours of inactivity, the device automatically proposes a self-disinfection cycle 93°C. The display
shows "PdIs". It is advisable to run the program without load, no load inside the washing chamber.
6.4 TROUBLESHOOTING
Refer to the full version of the operator’s manual for the countermeasures to be taken in the event of malfunctions or if
deterioration in the appliance’s performance is noticed even without the triggering of alarm signals.
6.5 ROUTINE INSPECTIONS AND MAINTENANCE
The full version of the operator’s manual, available on CD, contains details of the maintenance procedures recommended every
day, every week and every six months.
In addition: contact your nearest authorised service centre to have the appliance completely checked over at the end of the
warranty period and annually for successive years, or, if this occurs before the end of the year, when the “Appliance maintenance”
LED illuminates.
Maintenance operations are not covered by the product Warranty, which does not include the replacement of
components which deteriorate due to normal wear and tear.
WARNING
The manufacturer declines all responsibility in the event of malfunctions or damage arising from the failure to comply
with the above recommendations.
INFORMATION AND ASSISTANCE
(ref. par 5.4.1 IEC 61010-1:2001).
FOR ANY REQUEST FOR TECHNICAL SERVICE FOR THE PRODUCT,
WHETHER IN OR OUT OF WARRANTY,
DIRECTLY CONTACT THE TECHNICAL SUPPORT DEPARTMENT
OF THE DEALER OR RESELLER
THAT SUPPLIED THE PRODUCT.
For more information: MOCOM S.r.l. Via Saliceto, 22 - 40013 Castel Maggiore (BO) Italy
Tel. (+39) 051.703168 • Fax (+39) 051.700949 - e-mail: infomocom@mocom.it • www.mocom.it
To Previous Page
Loading...
