Tethys D60 - Tethys T60 - Tethys T45 SHORT-FORM MANUAL
2. a support, a conical rubber fitting, for positioning the intake pipe correctly;
3. the silicone hose for connection between stainless steel intake pipe and peristaltic pump.
4. Detergent intake filter, fitted directly on the stainless steel pipe.
WARNING
The label on the intake pipe must correspond to the type of detergent being used. Refer to the following colour code:
P1 - White/clear: alkaline detergent
P2 - Red: acid neutralising agent
P3 - Blue: optional additive
Connection errors reduce the effectiveness of the process and may damage parts of the circuit. Detergent intake system
connection errors lead to the loss of Warranty cover for the parts concerned.
The intake pipe is supplied complete with intake filter. Make sure that the filter is always fitted and correctly positioned
to keep the detergent dispensing system in good working order. Check regularly that the silicone hose is properly fixed
to the stainless steel intake pipe and that there are no leaks.
fig. 8 – Detergent intake STANDARD Tethys D60 configuration. Fitting the detergent intake pipe to the can. Fit the rubber cap over the top of the can
for a perfect, secure connection. The pipe is supplied complete with intake filter.
4.3 RECOMMENDED DETERGENTS
One fundamental factor for a good washing process is the type of detergents used.
The manufacturer guarantees excellent washing results with the use of the recommended products.
ATTENTION
Always comply with the INSTRUCTIONS provided by detergent PRODUCERS, especially with regard to the
RECOMMENDED DOSES, the correct TEMPERATURES for their use and STORAGE instructions. Safety information about
doses supplied in compliance with 5.4.4.s of IEC61010-1-040. Refer to the product instructions and technical safety data
sheets.
GENERAL PRECAUTIONS FOR DETERGENTS
HANDLE DETERGENT CANS WITH CARE
Detergents may be TOXIC. Refer to the product safety data sheets.
Once a product has run out, replace the empty can with a full can of the same product.
If the product left in the old can is poured into the new one, take care not to overfill the new cans to ensure that they
will not overflow when the suction nozzles are inserted. Gloves must be worn during any handling of
detergents.Information supplied in compliance with 5.4.3.m, 5.4.4.n and 5.4.4.q IEC61010-2-040:2005
DETERGENT SAFETY DATA SHEETS.
Detergent SAFETY DATA SHEETS must be kept: close to the place where detergents are stored, close to the appliance, in
an easily accessible location. The latest versions of the safety data sheets should be requested regularly (e.g. once a
year). Safety data sheets will be supplied by your dealer on request. Refer to safety data sheets for first aid procedures
in the event of accidental contact with detergents.
DISPOSAL
Information supplied in compliance with point 5.4.4.L of IEC61010-2-040:2005.
DISPOSAL of any product residues and containers (cans and bottles): refer to the “DISPOSAL ADVICE” section of product
safety data sheets. The appliance’s responsible authority must dispose of detergent residues and containers in
accordance with the relevant national or local legislation.
To Next Page
Loading...
