Mocom Tethys D60 - Setup Mode; Accessing the Setup Mode; Entering the Password; Cloc - Date and Time Parameters

Tethys D60 - Tethys T60 - Tethys T45 SHORT-FORM MANUAL
6
3. ENGINEER Level
4. FACTORY Level
This short-form manual does not provide a detailed description of the setup functions; only the procedure for changing the date
and time is described. Refer to the full-form operator's manual for details.
3.1 ACCESSING THE SETUP MODE / ENTERING THE PASSWORD
a. Hold button 5 - Functions down for 5 seconds. 4 dashes appear on the display.
b. Use the Selection buttons 4 and 8 to modify the individual characters of the password.
c. Press button 5 - Functions quickly to move on to the next character
d. Once the 4 characters of the password have been entered, confirm by holding down button 3 - Start/Stop.
e. Once the Setup mode has been accessed, the various items available can be scrolled using button 5 - Functions.
f. To quit the SETUP mode, hold down button 7 - Open door.
The items accessible from the SETUP menu are shown in the table below. To move on from one item to the next, press button 5 -
Functions quickly.
Setup Item
Description
Set
Appliance parameter setup - detailed explanation provided in full-form operator's manual.
Cloc
Time and date - explanation follows.
Filt
Drying filter counter. (Only appears on Tethys D60)
Press the Start/Stop button to display the number of absolute filter hours left before the maintenance message
appears. The initial default setting is 500. The value is in units. (Display only parameter, cannot be modified).
Tec
Appliance operating hour counter for maintenance. Press the Start/Stop button to display the number of cycles
left before the maintenance message appears. The initial default setting is 900. The value is in units. (Display only
parameter, cannot be modified).
Coun
Appliance total operation counter (display only parameter, cannot be modified).
PrEn
Setting which allows display and selection only of the washing programs actually of interest. (function introduced
from firmware version 4.6.xx.yy).
3.2 “CLOC” – DATE AND TIME PARAMETERS
The “Cloc” parameter allows the current time and date to be modified. This parameter can be modified with the user password.
1. To select the Cloc parameter, hold down button 3 - Start/Stop with “Cloc” on the display.
2. Use the Selection buttons 4 and 8 to modify the value of the parameter.
3. Press button 5 - Functions quickly move from one parameter to the next.
4. Hold down button 3 - Start/Stop to confirm the modification
5. Hold down button 7 - Open door to quit the parameter being modified and the Cloc function.
During modification, the parameter concerned flashes.
PARAMETER
DESCRIPTION
PARAMETER
DESCRIPTION
C1
Year, last two figures (00-99).
C4
Hour (1-24)
C2
Month (1-12)
C5
Minutes (0-59)
C3
Day (1-31)
C6
Seconds (0-59)
fig. 6 – Cloc parameters Hold down the Start/Stop button to access the parameters. Parameter C1 sets the current year.