34
Section 5 – Eurotherm Controller (3000 Series)
Refer to the 4
th
character in the model code on the serial tag and then the
model code in Section 9 to determine your controller type.
5.1 Operation
This section of the manual contains all essential information needed to operate the controller.
Contact Mokon Customer Service with controller problems as well as warranty and repair issues.
The controller is configured by model number. Inputs, outputs and alarm types are preset. Final
setup and configuration are done from the keypad. The controller has four basic modes: Operator
1, Operator 2, Operator 3 and the configuration mode.
The controller’s is default level is Operator 1, and is used for day to day operation.
Note: Operator 2, 3 and configuration are password protected.
Home List Navigation
To step through list levels press and hold the Page button until level 1 is obtained. Press the up
button or the down button to change levels.
To step through parameters within a particular list, press the Scroll button until the required
parameter is obtained.
To change the value (or state) of a parameter, press the Up button or the Down button.
*Refer to Section 5.1 Keys for button locations and descriptions.
To Next Page
Loading...