Molbio Trueprep AUTO v2 - Switching ON;OFF the Device; Placing Cartridge and Starting Run

®
7.3 Switching ON/OFF the Trueprep AUTO v2
®
7.3.1 Press the Power button to switch on the Trueprep AUTO v2. You will be prompted with the
message ‘Buffer Count’.
.
7.3.2 Later you will be prompted with the message for
7.3.3 Press the Power button, when following screen will be displayed, release the power button.
The device will turn off automatically within 30 seconds.
7.4 Placing the Cartridge in the device and starting the run
Important: Only use the cartridge provided in the corresponding sample prep kits.
7.4.1 Press the Eject button to open the cartridge holder. You will be prompted with the message
11
TRUEPREP AUTO
BUFFER COUNT
®
SHUTTING DOWN
INSERT CARTRIDGE
Figure 10: The cartridge holder opened after eject button is pressed
®
Trueprep AUTO v2