Fluidics Option Operations
5014166 D 35
Configuring Fluidics Software (Stations and Properties)
To use the ImageXpress
®
Fluidics option, you must configure fluidics
stations and properties.
This section details the Plate Acquisition Setup > Fluidics > Configure
location, but the procedures are the same if you access the functions
from the menu.
To configure fluidics software
1. In the MetaXpress Software, click Screening > Plate Acquisition
Setup.
Figure 2-3: Plate Acquisition Setup dialog
Note: The Configure Fluidic Stations functions are available at Devices
> Configure Fluidic Stations, in the simplified menu, Control >
ImageXpress > Configure Fluidics Stations, and from the Configure
Stations option from Plate Acquisition Setup > Configure > Fluidics.
ImageXpressOptionsUserGuide.book Page 35 Wednesday, September 9, 2015 3:54 PM
To Next Page
Loading...