Application and operation
Page 18 of 34
5 Application and operation
Always note:
• The handle may only be loaded in an axial direction.
• The device switches off for safety reasons if subjected to excessive
radial force.
• Large radial forces will damage the handle.
• If the cannula holder (connection for suction tube and suction
cannula) is subjected to excessive forces, the handle will be
damaged.
• All handling of the device requires precise knowledge and
compliance with these instructions for use.
• The device may only be used by specialist staff.
5.1 Vibrasat
®
Pro Console description of the operating elements
After switching on the device using the On / Off switch on the rear, a brief display test is
performed. After starting, the display shows the last set value when the device was switched
off (stroke rate per minute = vibration speed).
The stroke rate can be set between 3000 strokes per minute and 5000 strokes
per minute. The stroke rate can be set in standby mode and in vibration mode
in increments of 100. The Vibrasat
®
Pro features a boost function. A
description of this can be found in Chapter 5.2.1.1.
To Next Page
Loading...