Moller Vibrasat Pro - General Data

Vibrasat
®
Pro
Appendix
Page 29 of 34
11.2 General data
Transport and storage instructions:
Temperature
-10°C to +50°C
Air humidity
Less than 90% relative humidity
Weight with packaging:
Dimensions Vibrasat
®
Pro Wand with
packaging:
Width x height x depth:
400 mm x 85 mm x 190 mm
Dimensions Vibrasat
®
Pro Console with
packaging
Width x height x depth:
297 mm x 145 mm x 228 mm
Store device in a dry place.
Operating conditions:
Temperature
+10°C to + 25°C
Air humidity
30 to 75% relative humidity
Protection type
Vibrasat
®
Pro Console
IP 20
Vibrasat
®
Pro Wand
steam sterilisable
The Vibrasat
®
Pro is subject to particular precautionary measures in terms
of EMC and must be installed and commissioned in line with the current
EMC instructions.
The Vibrasat
®
Pro must not be stacked or set up next to or with other
devices.
If operation close to or stacked on other devices is necessary, the
Vibrasat
®
Pro must be observed in order to check proper operation with
this set-up.
A list of accessories with which the Vibrasat
®
Pro satisfies the
requirements as per 6.1 and 6.2 of IEC 60601-1-2 is provided in the
accessories appendix.
Operation of the Vibrasat
®
Pro with additional accessories such as
converters and lines which are not defined as suitable for use with the
device can result in increased electromagnetic emissions or reduced
interference immunity.