Help in the event of a fault
Page 22 of 34
7 Help in the event of a fault
The Vibrasat
®
Pro must not be opened by the user!
This chapter describes certain problems that may occur in connection with the Vibrasat
®
Pro
.
Several causes with possible solutions are given for each problem. Keep to the
troubleshooting order until the fault has been remedied.
Always switch the Vibrasat
®
Pro off before detaching or connecting the plug connections.
If an error cannot be remedied in this manner, contact the Möller Medical GmbH service
centre (service@moeller-medical.com).
No functionality,
the display is off
The device is not switched on or not connected to the power
supply properly.
Insert the mains cable properly into the mains power socket
and the Vibrasat
®
Pro and switch on the power switch.
Check the power supply, possibly switch on multiple
sockets, check supply lines.
Drive plunger still not
functioning
The handle connecting cable is not connected.
Check the plug connection.
Foot switch does not react
The connecting cable for the foot switch is not connected.
Check the plug connection.
If none of the measures described are successful, contact the Möller Medical GmbH
service centre.
To Next Page
Loading...