Page 24 of 34
The Vibrasat
®
Pro Console software can be updated via the USB service interface on the
rear. To update, proceed as follows:
1. Disconnect the Vibrasat
®
Pro Console from the power supply. Switch the mains
switch on the rear of the Vibrasat
®
Pro Console to ON.
2. Remove the protective cap from the USB service interface using the USB release key.
3. Copy the firmware made available by the service centre to a USB stick. The USB stick
must be empty and may only contain the firmware file (without subdirectories).
4. Insert the USB stick into the USB service interface.
5. Connect the Vibrasat
®
Pro Console to the power supply and observe the display.
6. The display briefly shows “UPd” followed by a sequence from “U1” to “U5”.
7. If the update was successful, “IO” is shown as the final display. If the update was not
successful, the respective update warning is shown (see table below) and the old
firmware is retained on the device. If a warning is shown, check the update steps or
contact the service centre.
8. Following a successful update, disconnect the Vibrasat
®
Pro Console from the mains.
9. Remove the USB stick and close the service centre using the USB cover.
10. Makes sure that the On/Off switch is set to On and connect the Vibrasat
®
Pro Console
to the mains. Observe the display.
11. Note the software version displayed. If it does not correspond with the update, repeat
the steps above.
12. The Vibrasat
®
Pro Console is now updated.
To Next Page
Loading...