3.7 Battery
Disassembly:
Foot mat. (If present)
Battery box cover.
Disconnect the battery negative “－”
cable, and then the positive “＋” cable.
Warning: Do not touch tools with any metal parts of the frame while disconnecting
positive “+” cable. A resulting short circuit could cause sparking and damage to the
battery.
Inspection: This motorcycle uses a lead/acid wet cell battery. Top up as required with
distilled water or battery electrolysis fluid
Assembly: Assembly is in reverse order of disassembly procedures.
Warning: First connect the positive “＋” cable and then the negative“－” cable.
3.8 Spark Plug
Disassemble:
Remove spark plug HT lead.
Note: Blow away deposits around the spark plug with blower before removing spark plug.
Otherwise, the dust may drop into cylinder resulting in damage to the engine.
Inspection: Check if spark plug has carbon deposits, is burned, or cracked. Use a steel
brush to remove carbon deposits and adjust the spark plug gap. Replace a burned or
cracked spark plug with new one.
To Next Page
Loading...